You are not logged in.
Pages: 1
I got an advisory on loose seat rails last MOT and as I have the seats out I thought I would see if I can do anything.
Is there anyway to tighten them up at all or do they need replacing?
I was thinking of nipping the channels a bit in a vice.
Offline
Your sliding rails? If so there is a bolt front back of each one holding them to the base and you can also take them off from the seat so i presume another four bolts facing upway. Is this not what MOT man means?
Offline
I think they are worn loose. It's not the actual fixings but the sliding rails.
Being part of the bed and also swiveling they get a lot of use. Get hold of the top of the seat back and shake and there is quite a lot of movement in all directions. Feels and sounds worse than it is I suspect.
If I can't adjust it out I will bolt them down rigid for the next MOT. Is that allowed?
Offline
Pages: 1