The Dispatch | Expert | Scudo Hub

Get help & share your Citroen Dispatch (Jumpy) | Peugeot Expert | Fiat Scudo tips

You are not logged in.

#1 2021-08-24 00:19:05

Stu-D
Member
From: Scotland
Registered: 2019-07-30
Posts: 128
Website

Where can I get bushes for this, or a cheap replacement?

Does anyone know where I can get this or the bushes/bolts? Drawing a blank every where I search for stock... and there's no way I'm paying £200 for a new one lol.

Any advice/info greatly appreciated.

VYJhG1.jpeg

Offline

#2 2021-08-24 00:21:38

Stu-D
Member
From: Scotland
Registered: 2019-07-30
Posts: 128
Website

Re: Where can I get bushes for this, or a cheap replacement?

Sorry to add this is for a 2004 Dispatch/1.9 D70

Offline

#3 2021-08-24 00:31:39

Pathfinder100
Member
From: South Yorkshire
Registered: 2021-07-19
Posts: 105

Re: Where can I get bushes for this, or a cheap replacement?

What are those two bars for?  They were rusting on mine before I cleaned them up and painted them. 

The bushes didn't look too good on mine either but they should go a little longer.

If you know what its actually called you could try here.

https://www.mister-auto.co.uk/peugeot/e … 2003-2006/ - not sure if this is your vehicle.

Offline

#4 2021-08-24 00:37:09

Stu-D
Member
From: Scotland
Registered: 2019-07-30
Posts: 128
Website

Re: Where can I get bushes for this, or a cheap replacement?

Pathfinder100 wrote:

What are those two bars for?  They were rusting on mine before I cleaned them up and painted them. 

The bushes didn't look too good on mine either but they should go a little longer.

If you know what its actually called you could try here.

https://www.mister-auto.co.uk/peugeot/e … 2003-2006/ - not sure if this is your vehicle.

Cheers bud, these are the rear load balance/anti roll/pan hard bars, all out of stock for the bushes though eveywhere I look, I've been running with a bodge exhaust and no back box, I was lazy and didnt add a downturn/slash so the exhaust gases have cooked that bush, it's gone and is rattling like buggery lol, van handles fine but the rattling/clunking is annoying.

Offline

#5 2021-08-24 01:16:25

Pathfinder100
Member
From: South Yorkshire
Registered: 2021-07-19
Posts: 105

Re: Where can I get bushes for this, or a cheap replacement?

I'm guessing you will need to improvise something for now.  I did a quick search and I can't find any, full stop, anywhere. hmm

Offline

#6 2021-08-24 01:27:41

Stu-D
Member
From: Scotland
Registered: 2019-07-30
Posts: 128
Website

Re: Where can I get bushes for this, or a cheap replacement?

Pathfinder100 wrote:

I'm guessing you will need to improvise something for now.  I did a quick search and I can't find any, full stop, anywhere. hmm

I was looking at these DIY polybush kits... cheaper than a lemforder or febi even if in stock Lol... I'm trying to be the master of bodge, but safe bodge, always been good before but this french guff is a challenge! smile

https://www.ebay.co.uk/itm/283325952222

Edit: The front sills are made of VW corrado front wings, propa bodge! tongue

Last edited by Stu-D (2021-08-24 01:32:53)

Offline

Board footer