The Dispatch | Expert | Scudo Hub

Get help & share your Citroen Dispatch (Jumpy) | Peugeot Expert | Fiat Scudo tips

You are not logged in.

#1 2024-04-06 20:05:54

lesd
Member
Registered: 2023-02-01
Posts: 11

Oil pump drive chain.

Hi all.
Does the dw8 2003 1.9d have a chain tentioner. The oil pump drive chain is really loose and noisy. Also does anyone have info on how to replace the chain for a new one.
Thanks.

Offline

#2 2024-04-07 01:41:11

kenbw2
Administrator
From: Preston
Registered: 2017-11-26
Posts: 1,282

Re: Oil pump drive chain.


2000 Citroen Dispatch 1.9TD XUD9 Camper Conversion
1999 Citroen Dispatch 1.9D DW8 Disassembled Camper Conversion
1996 Peugeot 806 1.9TD XUD9 Spare vehicle
1998 Citroen Synergie 1.9TD XUD9 Snapped timing belt

Offline

#3 2024-04-07 10:43:40

lesd
Member
Registered: 2023-02-01
Posts: 11

Re: Oil pump drive chain.

Thanks Kenbw2.
Found a few diagrams and they all show no tentioner. The chains slapping about, so trying to work out the easiest way of replacing.

Offline

#4 2024-04-08 23:52:07

JohnDragonMan
Member
From: Derby, East Midlands, UK
Registered: 2020-06-02
Posts: 402
Website

Re: Oil pump drive chain.

its more easy to replace the chain. as i recall the XUD and DW8 both use the same oil pumps so the chains thus should be the same. i swapped the oil pump and chain in a 200k mile XUD with one from a 30k mile DW8  while replacing the sump gasket. that 200k oil pump still held pressure but i did notice the oil light go out faster with the lower miles pump!

while you are in there, also replace the crank seal too just helps stop any future leaks.


- JohnDragonMan
Notice: I have the tendency to void warranties, blow fuses, cause fires, and other fun stuff.
Words of wisdom: Internally rust proof the sills and subframe! both skins!!. There's always user serviceable parts inside. "Oh that shouldn't have happened".
My 2005 Dispatch Camper Project big_smile

Offline

#5 2024-04-28 19:57:10

lesd
Member
Registered: 2023-02-01
Posts: 11

Re: Oil pump drive chain.

Thanks for the reply.
I changed the chain for a new one. Bit of a fiddly job which entailed removing the crank sprocket, so replaced the seal while at it. Surprised it didn't have a tentioner as the old chain had stretched to a good half link longer than the new one.
Now going to have to do it again, as the shell bearings need replacing and the sump has developed a rust hole on the front!

Last edited by lesd (2024-04-28 19:58:11)

Offline

Board footer