You are not logged in.
Pages: 1
Citreon dispatch diesel 1.9 found i am loosing water from what appears to be behind the timing belt pulley at the bottom. I assuming its the water pump leaking.
Any advice and tips for removal and replacement please. Going to have to tackle it myself outside on a car jack, no pit or ramp.
Thank you in advance, ian
how much are you wanting for the spare wheel bracket, also any photos of it please.
thank you
i am looking for the rear brake compensator valve for my Citroen dispatch 1.9 van...potential MOT failure the pressed steel "lever" has corroded through on one side of the spivot pin. whole valve or just the intact lever please.
anyone with a spare valve for sale or just the pressed steel lever for the rear brake compensator valve.please
any links to the thread about the side doors? yes its the starter motor bolts that are now obsolete apparently,
Been back to it again this morning,slackend off the torx screws on the stricker plates fitted to the side of the van both sides, moved them out as far as possible 3/4mm by the looks of it, slide doors back...nothing still not catching? bizarre, I am seriously looking into bungy cord to hold them shut know-nothing seems to have moved, broken or dropped off so I am at a dead end.any other suggestions, also when replacing starter motor one of the bolts sheared, I am told they are obsolete? anyone have any spares for sale please.ian
been out to it again this morning,niether of the lock switches have no effect, yes one door (drivers side) was stuck shut when i bought the van the other seemed ok till if flew open as i was driving it home.Ive looked at the striker plate and catch at the back of the door and again neither seem to have been messed with.I will have another mess around later, it is very midgey at the moment so not battling against them just now.but thank you for your help so far fellas.ian
yes its very strange as they are both doing the same, its as if they are not quite closings thought something was trapped in the door.Flicking the locking lever from inside whilst holding the door closed doesn't do it either, nor turning the key with door held in place with handle from outside.
It is like the catch at the back isn't moving down when it hits the peg/catch part?
The little pin on the door is locating into the little black rubber grommets on the door pillar are lining up ok.
no they are not locking by the key or the little switch/lever inside up and down action.they slide fine back and forward just don't close and stay closed?
both side sliding doors are not closing properly,they shut but no lock activated so just slide open again.I have taken off the plastic trim cover inside to expose the workings but cannot see anything broken or missing.any help please..ian
Pages: 1