The Dispatch | Expert | Scudo Hub

Marcsdispatch

Member

Registered: 2021-07-01

Posts: 3

2008 Dispatch Air Suspension Fault

Hi

Is there anyway to reset the air suspension fault light that comes up on my dashboard?  Van drives fine, suspension pumps up as it should ( in fact it had 2 new air bags less than 12 months ago )
The beep and the warning are just starting to grate me now

Any help would be greatly appreciated

OAT

Member

From: Borders/Dales

Registered: 2017-01-03

Posts: 1,013

Re: 2008 Dispatch Air Suspension Fault

Surely it hasn't been going since you had the new air bags fitted?

Don't know if it's one of the lights that can easily be turned of by OBD scanners or not.  Don't have air suspension (or scanner connection) on mine, didn't realise how early it was fitted.

Marcsdispatch

Member

Registered: 2021-07-01

Posts: 3

Re: 2008 Dispatch Air Suspension Fault

No all was fine for a good few months, like i mentioned the actual air suspension is working fine which makes me think its some sort of sensor issue? I'll see if I can find someone local with a scanner to see if it can be knocked off ?

Surely it hasn't been going since you had the new air bags fitted?

Don't know if it's one of the lights that can easily be turned of by OBD scanners or not.  Don't have air suspension (or scanner connection) on mine, didn't realise how early it was fitted.

vaz2121

Member

From: Glasgow Living:~ SW. Scotland

Registered: 2015-08-31

Posts: 1,311

Re: 2008 Dispatch Air Suspension Fault

This sounds like it could be a historical fault in ecu flagging up a code that maybe needed reset when air bags replaced.......
Although as it had put light out ...  As you say it could be a sensor .............
As I've said before "New doesn't mean better"............

There is the possability that with the light being out for a bit and now returned that the air bags are a tad to high or low [over or under inflated] and sensor has picked it up..............
Hence clear all previous faults............

Getting a full code reading is the way to go.........
[Generic home hobby readers usually only see and deal with P codes {power train = engine codes}] ............

At least you'll know what codes remain afterwards are what then ................

P7W

Member

Registered: 2023-12-21

Posts: 1

Re: 2008 Dispatch Air Suspension Fault

Hi, I'm wondering if you managed to resolve this problem and if so, how? I have a similar problem on a 2008 Wheelhome camper van conversion of a Scudo. Suspension seems to be working fine - goes up and down manually using the button; self adjusts when starting/stopping, etc. But dash light permanently on. I have heard (and have found) that you can re-set by driving over 10mph for 15 min, then turning the engine off and back on again (while stopped, obv!), but this has not worked this time. It seems like its probably a sensor issue to me, but I was getting a regular double bleep from what seems to be the rear suspension controller, off and on for a couple of weeks before the dash light came on. Didn't come on when beeping though. And now the beeping doesn't seem to happen (well, didn't today when I tried another re-set!). I have an OBD11 reader but it is not showing any faults. Any help /advice/ insight gratefully received!