The Dispatch | Expert | Scudo Hub

Hammersfixeverything

Member

From: Cardiff

Registered: 2024-09-28

Posts: 57

Been Busy, installed rear seats

After alot of time of Gumtree and FB Market place I found seats for me to install in the van ( I now have a lot of spare seats)

This Wav did have a single rear seat, but also had the blots in the otherside. So I made a bench!

Plus the Mobility scooter still fits 

Last edited by Hammersfixeverything (2025-07-21 16:59:34)

---

The Caretaker of
87 Polo Mk2
97 Corsa B
07 Dispatch WAV

kenbw2

Administrator

From: Preston

Registered: 2017-11-26

Posts: 1,621

Re: Been Busy, installed rear seats

Noice. Proper 3 point seat belts and everything! And they match the van

How'd you bolt them into the floor?

---

2000 Citroen Dispatch 1.9TD XUD9 Camper Conversion
1999 Citroen Dispatch 1.9D DW8 Disassembled Camper Conversion
1996 Peugeot 806 1.9TD XUD9 Spare vehicle
1998 Citroen Synergie 1.9TD XUD9 Snapped timing belt

Hammersfixeverything

Member

From: Cardiff

Registered: 2024-09-28

Posts: 57

Re: Been Busy, installed rear seats

As its a Wav it already had 1 seat, so I reused those mounts/ bolts. The other side had the bolts already installed but the wrong way around (as you need the treads pointing out of the floor to mount the seat)

The bolts I used in the end, go stright though the chassis with reinforcing steel plates. They where already there from the wav converstion.
The other bolts just go stright though the floor but there are heavy duty steel plates on both sides that the bolt goes though before the floor from the underside.

The seats themsleves are from a buses, I have 4 spare seats with legs which I need to sell or something. I brought all one ones near me to see what will work. All the seats are singles, I just bolted the ones I installed togther with overthe top hardware. Going to take it the garage i use this week, just for them to look it over and make sure its all ok.

---

The Caretaker of
87 Polo Mk2
97 Corsa B
07 Dispatch WAV