You are not logged in.
Pages: 1
Hi
Whilst I was fiddling with my heater display bulbs I happened to remove my hazard switch and saw there was some additional wiring in place that was not connected. Is this for front fogs? It seemed to match up to where one of the blanking plates is next to the hazard switch. It made me wonder if the wiring is all there for the front fogs and what other Citroen fogs would fit or aftermarket ones could be made to fit. Anybody tried this??
Cheers
2004 Citroen Dispatch 2.0 Hdi
Offline
Peugeot are good at having one loom fits all so i dare say Citroen could be the same. Make sure you have the wire at the other end go to scrap yard and get the lights and switch from a scrapper and plumb in. You may need a fuse only or a relay so look at a wire diagram.
Offline
Has anyone fitted after market spots/fogs? There's not much room on the bumper, has anyone made there own bracket? I found some Ring Rally Giants in my shed and fancied pimping up the front end.
2004 Citroen Dispatch 2.0 Hdi
Offline
Found this quite some time back
http://www.ebay.co.uk/itm/252717538499? … EBIDX%3AIT
Been wondering if it would be of any use and would last more than a couple of wet days before turning to rust
I haven't bothered to do anymore than think about it as I have a couple of other projects that are taking precedence
Offline
The blanks on the centre console are for heated rear windows and heated mirrors I believe. The fog lights are controlled via the light stalk on the left hand side of the steering wheel.
Offline
Pages: 1