You are not logged in.
Pages: 1
Head gasket went last week on my 2.0hdi dispatch. Three of the bolt heads that hold the head on sheared off. Any ideas on how to get these out? The garage says that because the flanges haven't broken off, just the hexagonal heads, they can't be drilled out...
Anyone know where I can get an engine?
Thanks ?
Offline
Jeezo - bad luck.
Can I ask how many miles the engine had done? Were there any signs of problems before it happened?
I guess you need to find out exactly what engine was in there first - the 2.0hdi is one of the DW10 engines I believe - but there are several variants of it I think. DW10ATED, DW10BTED, DW10CTED etc.
After that I guess ebay's a good place to start .. never had to buy an engine though!
So far ...
Good luck
2006 Citroen Dispatch 2.0HDi bought in July 2013 - Partial camper conversion ........

Offline
It'd done 127k RHZ engine according to logbook. only had it a month! They're were no signs of it under the water and oil caps. Not using water or oil either. Completely out of the blue!
No joy on eBay but used 1st choice and found an engine for £300 that'd only done 74k. Pity about the old one, it ran well. I'm sure there would have been a specialist company that would be able to drill out the bolts but couldn't find one..
Offline
I have the RHZ too - but think I'm way up beyond 140k now. Although my mechanic says he's seen some of the taxis go past 300k.
I'd really appreciate updates on your progress with this - £300 for a 74k engine sounds like a decent price.
My van's semi-converted to camper and there's quite a lot of work gone into it, so I've always been curious about the price / process of getting the engine completely replaced if mine went since I couldn't just swap the whole thing out for another van.
Hope it all works out!
2006 Citroen Dispatch 2.0HDi bought in July 2013 - Partial camper conversion ........

Offline
Love to hear more on this too .. constantly kackin it that my engine will go and have no idea if it's feasible to think about changin it ...
Good luck and keep us posted Skxawng
Offline
So how did it pan out? My head gasket's gone too, think it was caused by overheating. I'm in the same situation but haven't started work yet.
Offline
If its only the nut head blown off then once your head is off are there not studs still sticking up? If so use easy outs
Offline
Pages: 1