2001 2.0 hdi clutch

propermad · 2021-10-31 22:04:41

hey guys
a bit of desperation really, clutch suddenly to floor pulled back up and worked for a short time then went again for good.
now im thinking pull/push mechanism gone or hydraulics wishfully.
problem i have is no feck7ng manual i dont know if its hydraulic or cable (strange mechanism on footpedal) i cant find a master cylinder or reservoir
it looks like its a push bearing but the actuating arm has a cup which suggests a pull bearing, arm was over to the left looking down.
any suggestions ? i know im probably looking at a clutch.
any help would be greatly appreciated.

OAT · 2021-10-31 22:29:54

Don't know what van you have but at least on early models like mine, they have a self adjusting cable which can fail giving the impression of clutch failure.

When mine went the pedal would go to the floor with no resistance at all. It could then be pulled back up against a little resistance and would work again. Until it randomly did it again.

Almost went for a new clutch but ended up just replacing the cable and all was well.

This vid suggest a fix without even replacing the cable:-

https://www.youtube.com/watch?v=h7OrXuahEjo

Just noticed yours is 2001 and likely to be this type of cable.

Last edited by OAT (2021-10-31 22:36:31)

OAT · 2021-10-31 22:43:06

Don't know where you might get just the clip but part numbers here for cable:-

https://triscan.dk/sites/default/files/ … les_GB.pdf

propermad · 2021-10-31 22:54:45

OAT wrote:

Don't know what van you have but at least on early models like mine, they have a self adjusting cable which can fail giving the impression of clutch failure.
When mine went the pedal would go to the floor with no resistance at all. It could then be pulled back up against a little resistance and would work again. Until it randomly did it again.
Almost went for a new clutch but ended up just replacing the cable and all was well.
This vid suggest a fix without even replacing the cable:-
https://www.youtube.com/watch?v=h7OrXuahEjo
Just noticed yours is 2001 and likely to be this type of cable.

thanks for the response, i was under it today and all i can find is a hydraulic pipe across the bulkhead, where is the cable?

OAT · 2021-11-01 00:35:24

Any help?:-

https://dispatchexpertscudo.org.uk/foru … hp?id=1479

If not, Ken will hopefully be along to help further.

Last edited by OAT (2021-11-01 00:37:07)

vaz2121 · 2021-11-02 00:58:07

I have a 2005 815 enterprise converted Citroen Dispatch Fitted with A DW8 and it's clutch is hydraulic IIRC the slave cylinder is visible at front of G box behind passengers side of radiator

The Dispatch | Expert | Scudo Hub

Get help & share your Citroen Dispatch (Jumpy) | Peugeot Expert | Fiat Scudo tips

#1 2021-10-31 22:04:41

2001 2.0 hdi clutch

#2 2021-10-31 22:29:54

Re: 2001 2.0 hdi clutch

#3 2021-10-31 22:43:06

Re: 2001 2.0 hdi clutch

#4 2021-10-31 22:54:45

Re: 2001 2.0 hdi clutch

#5 2021-11-01 00:35:24

Re: 2001 2.0 hdi clutch

#6 2021-11-02 00:58:07

Re: 2001 2.0 hdi clutch

Board footer