The Dispatch | Expert | Scudo Hub

Howesmob

Member

Registered: 2022-10-18

Posts: 1

Relays?

Good Evening fellow Jumpy owners.  I wonder if anyone can point me in the direction of a potentially faulty relay.  I have a 2013 1.6HDI Dispatch with a really annoying problem.  My headlights work fine until I put them on high-beam.  As soon as I pull the stalk, both headlights go out but side lights stay on.  I have checked the bulbs and fuses, no problems there.  I have taken the stalk assembly off, taken it apart and cleaned all connections but it did not make a difference.  Everything else works on the stalks so I wondered if there is a relay in need of replacement.  The issue is, I cannot find any relays, anywhere.  I have located a fuse box behind the drivers side plastics, below the cup holder and the fuse box under the bonnet.  Does anyone know if a panel of relays exists or can suggest the cause of my problem?  As a last resort I will have to buy a new stalk assembly but as they are not cheap, I wanted to make sure I have covered all possible potential issues.  Thanks in advance.

AlvyLad

Member

Registered: 2021-06-11

Posts: 486

Re: Relays?

AFAIK all (or most) of the relays are on the fuse box/"mounting plate" ('s), which is what?- perhaps somebody will come up with better expertise to help you out in the right direction

tee_cee

Member

Registered: 2016-03-18

Posts: 636

Re: Relays?

That fusebox in the engine aka PSF1 or BSM also contains the headlight power components.
Since the stalk high beam switch is being detected, and the dip beams are working, the fault must be in the PSF1
Unfortunately the BSM is not repairable, so you would need a replacement. I see a few of these on eBay, where they say it needs to be coded, but I doubt that this is the case.

Last edited by tee_cee (2022-10-20 17:13:32)