The Dispatch | Expert | Scudo Hub

Joshwaa

Member

From: Scarborough

Registered: 2024-10-05

Posts: 19

2005 Dispatch 2.0HDI - P0190 + P0380

So after the sucess of getting my van back going I've decided to investigate into an issue I've had since I've got the van 4 year ago

EML light is always illuminated (apart from when i take bulb out for MOT)

Codes read

P0190 - Fuel rail pressure sensor A circuit

P0380 - glow plug heater circuit A

The van sounds lumpy and is in a ½ limp mode doesn't pull over great up hill and it's not very quick off the mark. Almost like a 2.0 flat diesel with no boost....limp mode.

So,

Fuel filter gets done every 6 month during service

In tank pump has been changed recently from trying to cure a non stater - now solved and loads of low pressure there....like a tap

No diesel leaks

Seals okay on Fuel filter housing

Is it worth just throwing a fuel rail pressure sensor on?

If nothing comes from this I'll get it into a garage and go from there.

Any help appreciated

RegW

Member

From: Bristol

Registered: 2024-04-21

Posts: 349

Re: 2005 Dispatch 2.0HDI - P0190 + P0380

how did you change the tank pump?  do you have to drop the tank?

---

When all else fails, RTFM  - 2006 Expert 2.0 HDI/110

Joshwaa

Member

From: Scarborough

Registered: 2024-10-05

Posts: 19

Re: 2005 Dispatch 2.0HDI - P0190 + P0380

how did you change the tank pump?  do you have to drop the tank?

Make sure you're tanks near on empty makes its easier....

It's held in on a cradle with 3 bolts. 2 at "front" and 1 at the rear  I managed to drop the front 2 bolt and that gave enough give to do it, abit fiddly. There is a video on youtube where the guy drops the full tank with in depth instructions as well