The Dispatch | Expert | Scudo Hub

spence141

Member

Registered: 2025-05-18

Posts: 1

Dispatch 2010

HI I have recently purchased a dispatch which had glow plug/ pre heat relay code so I changed the glow plugs (not a nice job) . this code has now gone but the van will not start until the outside temp has risen above about 20 . it has the triangle warning light on and this goes in the afternoon when the temp goes up outside . it now has codes f4ba and f5ff relating to immobiliser issue and bsi . i changed the battery as it went flat with all the cranking and diag  done . if its left off for a while and reconnected it will stop the van being in standby mode but as the van wont start it wont come out of this mode without doing the disconnection and reconnection. Any ideas would be very much appreciated

Changed glow plugs,relay and battery

Last edited by spence141 (2025-05-18 11:55:01)