You are not logged in.
Pages: 1
Anyone got a naked side door and can measure the section arrowed. See how its two sections i need from Left, left section to Right, Right section and top to bottom as ill be cutting out that support bar to fit glass. Anyone looking to DIY glass there own doors dont look for van or caravan windows as they charge the earth. Look at boat windows. Save a fortune.
Offline
If you can wait until tomorrow, I am swapping my doors with taxi doors and I can take the ply off the old door and measure it.
Offline
If you can wait until tomorrow, I am swapping my doors with taxi doors and I can take the ply off the old door and measure it.
Cheers mate yes. Just wanting the size before i go ordering anything.
Offline
I apologise for the mixture of measurements.
The left and right sections both measure 1ft wide and 38cm highs.
The full width from lip to lip including the support bar is 66 and a half cm.
I hope this is what you wanted measuring?
Offline
I apologise for the mixture of measurements.
The left and right sections both measure 1ft wide and 38cm highs.
The full width from lip to lip including the support bar is 66 and a half cm.I hope this is what you wanted measuring?
Cheers mate thats grand. So 38cm x 66sm is my window size. Ill fo 1cm less each way as i am just looking to pop rivet ones in place.
Offline
All the measurements were to the innermost lip inside the square sections.
Offline
All the measurements were to the innermost lip inside the square sections.
Someone round the corner from me has a Scudo with nice looking sliding Pop riveted windows. I have knocked on a few doors to find out who owns it to as where they got them but no one knows. It has been moved a few times so they must stay here. If it was dumped i was going to have them.
Cheers mate, appreciated.
Offline
Pages: 1