The Dispatch | Expert | Scudo Hub

Get help & share your Citroen Dispatch (Jumpy) | Peugeot Expert | Fiat Scudo tips

You are not logged in.

#1 2019-09-23 19:10:33

Registered: 2019-09-23
Posts: 1

Heater blower... again

Hi guys I just found your forum smile
I have just purchased a 2006 Peugeot Expert 1.9D. The blower motor isn't working. On further investigation it appears that the plug that connects to the blower motor has melted at some point. I already bought a replacement motor. My issue is that someone cut the connector plug off from the harness and has put spade connectors on instead. I don't know which way to connect them to the motor. I have 3 wires. Does anyone know how to connect them correctly? Thanks


#2 2019-09-25 14:20:48

From: Borders/Dales
Registered: 2017-01-03
Posts: 448

Re: Heater blower... again

Bear in mind that mine is an earlier van...

The block connector from the loom has three female spade connections.  These connectors are numbered from left to right - 4 - 3 - 2 - 1
There are three wires - 1 red, 1 thin green, 1 thick green with yellow flashes.

Red to 4
Thin green to 3
Thick green to 2
Nothing to connector 1

Hopefully you can see the corresponding numbers on the motor connector.


Board footer