The Dispatch | Expert | Scudo Hub

Get help & share your Citroen Dispatch (Jumpy) | Peugeot Expert | Fiat Scudo tips

You are not logged in.

#1 2018-11-07 09:03:57

cliffo
Member
Registered: 2017-08-04
Posts: 62

Offside rear door, internal locking

Hi all

When the double bed is made up in the van I plan to use the offside rear door for entry / egress.

However, there is no way to 're-lock' this door from the inside (a key would do it from the outside).

Before I pull the door panel off and investigate to see if I can put a cable in there, or something, does anyone have any thoughts? Do any of these vans come with a locking button/lever thingy on the inside of this door?

Online

#2 2018-11-07 10:12:44

Casper
Member
From: East Lothian
Registered: 2015-12-20
Posts: 1,207

Re: Offside rear door, internal locking

For the size of the van would stretching over to operate the central locking on the sliding door not cut it? I had an issue with my back doors vibrating open when driving. I ended up putting a drop bolt on the door and into the floor what cured that. You could put a nice brass one on the inside of the O/S door and just use that if you dont have CL.

Offline

#3 2018-11-07 11:27:44

kenbw2
Member
From: Bradford/Preston/Anywhere
Registered: 2017-11-26
Posts: 236

Re: Offside rear door, internal locking

Definitely doable. I pulled mine out and attached a cable to the mechanism that turns when you turn the key.

I'm trying to remember exactly how I did it. I think I took the door handle out and watched it as I turned the key. Tie it to the plastic loop then feed it through the door to the inside.

f1vvIaG.jpg


1999 Citroen Dispatch 1.9D DW8 Camper Conversion
1996 Peugeot 806 1.9TD XUD9 Spare vehicle
1998 Citroen Synergie 1.9TD XUD9 Snapped timing belt

Offline

#4 2018-11-07 21:35:18

cliffo
Member
Registered: 2017-08-04
Posts: 62

Re: Offside rear door, internal locking

Yeah, no CL in SteVan, Casper, so may consider extra hardware but will probably end up with Ken's solution - cheers

Online

#5 2018-11-08 02:28:08

OAT
Member
From: Borders/Dales
Registered: 2017-01-03
Posts: 231

Re: Offside rear door, internal locking

There is a convenient cut out in mine which allows a finger to be poked in to lock it.  Probably by the same link Kens cable attaches to.

I will post some pics tomorrow.

Offline

#6 2018-11-08 16:43:02

OAT
Member
From: Borders/Dales
Registered: 2017-01-03
Posts: 231

Re: Offside rear door, internal locking

Can be locked by clicking the black plastic bit upwards.

P1100541.jpg

P1100542.jpg

Last edited by OAT (2018-11-08 16:44:09)

Offline

#7 2018-11-09 04:35:05

cliffo
Member
Registered: 2017-08-04
Posts: 62

Re: Offside rear door, internal locking

OAT wrote:

Can be locked by clicking the black plastic bit upwards.

Hmm, very interesting - cheers

Online

#8 2018-11-09 11:39:34

Casper
Member
From: East Lothian
Registered: 2015-12-20
Posts: 1,207

Re: Offside rear door, internal locking

Cant remember that hole. Did you cut that out Oat?

Offline

#9 2018-11-09 20:44:26

Tiree
Administrator
From: Castle Douglas
Registered: 2013-09-20
Posts: 190

Re: Offside rear door, internal locking

Mine doesn't have that but I'm getting the hole cutters out in the morning! Thanks for the tip!


2006 Citroen Dispatch 2.0HDi bought in July 2013 - Partial camper conversion ........

mini_citroen-dispatch2.jpeg

Offline

#10 2018-11-11 13:24:39

OAT
Member
From: Borders/Dales
Registered: 2017-01-03
Posts: 231

Re: Offside rear door, internal locking

Casper wrote:

Cant remember that hole. Did you cut that out Oat?

No not me.  Tis a factory conversion though so probably done by them.  Just needed a panel with a little lever to finish it off really.


Careful where you drill Tiree,  there are flanges and mounts for the lock behind there.  No way to see them till you cut.  I think a single 50 - 60mm hole in the right place would suffice.  The lever only needs the slightest push from one finger to click the lock.

I will post some measurements later.

The centre of the linkage you are looking for is 6" down from the curve into the window recess and 3" in from the door edge.  At that centre your pilot hole will miss the bracket behind.

P1100543.jpg

Last edited by OAT (2018-11-11 15:12:33)

Offline

#11 2018-12-28 16:49:18

Tiree
Administrator
From: Castle Douglas
Registered: 2013-09-20
Posts: 190

Re: Offside rear door, internal locking

Apologies - meant to reply to this ages ago.

In the end I didn't need the hole-cutters as it turned out my van also had a hole there - albeit it much smaller [the same size as the two below it]

IMG_20181228_142358.jpg

Removing the rubber stopper allows enough access to activate the lock mechanism in OAT's picture.

All of this is good for me as the rear door lock barrel seized on my van about a year ago!


2006 Citroen Dispatch 2.0HDi bought in July 2013 - Partial camper conversion ........

mini_citroen-dispatch2.jpeg

Offline

Board footer