The Dispatch | Expert | Scudo Hub

Get help & share your Citroen Dispatch (Jumpy) | Peugeot Expert | Fiat Scudo tips

You are not logged in.

#1 2019-05-12 17:12:22

Casper
Member
From: East Lothian
Registered: 2015-12-20
Posts: 2,180

Spare wheel hanger

Mine is missing and going to look and order a 2nd hand one next week. I presume this is the hanger as i have two but what hole for the pivot pin?

20190512-124125.jpg

Offline

#2 2019-05-13 21:08:22

OAT
Member
From: Borders/Dales
Registered: 2017-01-03
Posts: 1,013

Re: Spare wheel hanger

Mine has three holes and the hanger is in the middle one.

The two outer holes are pressed through to form a raised boss on one side.  The middle one that mine uses is just a drilled hole.

Perhaps different mounts for different batches of silencer, axle, etc?

Offline

#3 2019-05-13 23:28:46

kenbw2
Administrator
From: Preston
Registered: 2017-11-26
Posts: 1,612

Re: Spare wheel hanger

Or maybe for the ones that have 14" rather than 15" wheels


2000 Citroen Dispatch 1.9TD XUD9 Camper Conversion
1999 Citroen Dispatch 1.9D DW8 Disassembled Camper Conversion
1996 Peugeot 806 1.9TD XUD9 Spare vehicle
1998 Citroen Synergie 1.9TD XUD9 Snapped timing belt

Offline

#4 2019-05-13 23:45:12

Casper
Member
From: East Lothian
Registered: 2015-12-20
Posts: 2,180

Re: Spare wheel hanger

kenbw2 wrote:

Or maybe for the ones that have 14" rather than 15" wheels

So there is two sizes. I was looking the other night as i have 195/70/14 but when searching 15" kept coming back what was confusing.

Offline

#5 2020-01-12 18:32:12

RedSquirrel
Member
Registered: 2020-01-12
Posts: 15

Re: Spare wheel hanger

Looking at the rust under your van indicates some gloop might be in order. I have been using https://www.lanoguard.co.uk/products/bo … r-care-kit and Fluid Film for treating rust. It’s lanolin based, so if you’re partial to sheep, it has a nice aroma.

I had an inner wing on a 405 welded up, just behind the front wheel. I coated it with the grease version, and warmed it up with a heat gun to spread it. In the following three years, if you scraped the steel with a fingernail, it was shiny steel behind. It’s ironic it later failed the MOT because of rust on the BACK axle. That was the end of life. Doh!

Offline

#6 2020-01-12 23:08:34

Casper
Member
From: East Lothian
Registered: 2015-12-20
Posts: 2,180

Re: Spare wheel hanger

The other van is overdue sealer again also. Ill wait and see how the MOT goes on the disparch. If a pass ill do that but if wanting lots of work ill just get another. Mine is just for work unlike if it was a camper i would take more care of it.

Offline

#7 2020-01-13 11:32:06

RedSquirrel
Member
Registered: 2020-01-12
Posts: 15

Re: Spare wheel hanger

smile  Mine is just for work, so it’s important it keeps going as it earns the money.

Offline

Board footer