The Dispatch | Expert | Scudo Hub

Get help & share your Citroen Dispatch (Jumpy) | Peugeot Expert | Fiat Scudo tips

You are not logged in.

#1 2020-01-29 17:49:47

nigelweepers
Member
Registered: 2020-01-29
Posts: 2

Aftermarket Keyless Entry, Remote Central locking kit for 07 Expert

I have just bought an 07 Peugeot Expert. I only have one key, which just turns in the locks. The key is NOT the folding type with buttons.
I have bought an aftermarket 'keyless entry system' but I am stumped with the installation.
I can remotely lock the van but not unlock it.
Has any forum member managed to install one of these kits?

Nigel

Offline

#2 2020-01-29 18:19:59

Rabnudj
Member
Registered: 2019-05-04
Posts: 22

Re: Aftermarket Keyless Entry, Remote Central locking kit for 07 Expert

Yes,

I installed one made by a company called hawk about two years ago. Best thing I every did!

If I remember correctly, it had several wiring diagrams of the typical setup on cars. I recall that the system on our van holds both terminals of the actuators to ground when idle. Therefore, if you want to send a positive pulse, there needs to be a break in the feed from the oem wiring or you get a short! I found out the hard way.

I made all my connections at the BSI module which is found under the steering wheel to the right behind the cubby hole.

Ask me some specific question and I'll try to help

James

Offline

#3 2020-01-29 18:54:03

nigelweepers
Member
Registered: 2020-01-29
Posts: 2

Re: Aftermarket Keyless Entry, Remote Central locking kit for 07 Expert

That’s it. I need to BREAK a circuit not MAKE a circuit. I am going to cut a wire and wire it through the unlock relay. NC not NO.

If I’m successful I’ll post the instructions.

Offline

Board footer